If a pipe bursts, shut off your main water valve first. In most homes in the Central Valley and Orange County, it is near a front hose bib, in the garage, or in the meter box by the curb. Next, turn off the water heater and stay away from wet outlets. Then call a plumber.
The First 10 Minutes, Step by Step
Start with the valve. A burst pipe can put many gallons of water on your floor every minute. Don't reach for towels first. Every minute the water runs, it soaks deeper into drywall, carpet pad and the floor below.
Read these steps now, before you need them. In the moment, most people lose time hunting for the shutoff.
Step 1: Shut Off the Main Water
This valve stops water to the whole house. In most California homes, from Fresno to Irvine, it is usually in one of these spots:
- Front of the house. Look near a hose bib where a pipe comes up out of the ground.
- In the garage. Some homes have the main valve on a garage wall.
- At the meter box by the curb. Lift the lid. The valve there often needs a meter key.
A gate valve has a round handle like a small wheel. Turn it clockwise until it stops, but don't force it. A ball valve has a flat lever. Turn it a quarter turn so the lever sits across the pipe.
A meter key is a long T-shaped tool sold at hardware stores. Buy one now and hang it in the garage. If the house valve won't turn, use the meter valve.
Step 2: Turn Off the Water Heater
Now the tank gets no new water. If hot water drains out of the tank, a heater that keeps firing can be damaged. How you shut it off depends on the type.
- Gas tank heater. Turn the gas control knob to Pilot or Off.
- Electric tank heater. Switch off its breaker at the electrical panel.
- Tankless heater. Turn off its power switch or unplug it.
Is the leak coming from the water heater itself? Then also close the cold water valve. It is on the pipe that goes into the top of the tank. If you smell gas near the heater, don't touch anything. Skip to the gas section at the end of this post.
Step 3: Stay Safe Around Water and Power
Water and power don't mix. Never walk into standing water that could be touching outlets, power strips, cords or appliances. If water is coming through a ceiling near a light, stay out of that room.
- Dry path to the panel. Turn off the breakers for the wet area.
- Water between you and the panel. Don't go. Call your electric company.
- Plugs and cords. Never unplug anything while standing in water or with wet hands.
- Kids and pets. Keep them out of wet rooms.
Step 4: Open Faucets to Drain the Lines
Your pipes are still full. Open a cold faucet at the lowest point in the house, like a tub spout on the ground floor. Then open a faucet on the top floor to let air in. This drains what is left and takes pressure off the broken pipe.
Step 5: Move Valuables and Start Drying
- Move electronics, papers, photos and rugs out of the wet area.
- Put foil or plastic under furniture legs to stop stains.
- Mop and towel up standing water once the power is safe.
- Lift wet area rugs off carpet so both can dry.
- Open windows and run fans if the power in that room is safe.
Don't pull up wet carpet or cut open walls yet. Your insurance company may want to see the damage first.
Step 6: Take Photos and Video
Grab your phone before you clean up too much. Get wide shots of each room. Then get close-ups of the broken pipe, the ceiling, walls, floors and damaged items. Keep the broken piece of pipe if the plumber removes it.
Fixture Shutoff Valves: Stop One Leak, Keep the Water On
Not every leak needs the main off. Most sinks, toilets and appliances have their own small shutoff valve. Plumbers often call these angle stops. Turning one off stops the leak at that fixture and keeps water on everywhere else.
- Toilet. The valve is low on the wall behind the toilet.
- Sinks. Look inside the cabinet for one hot and one cold valve.
- Dishwasher. Check under the kitchen sink, often on the hot line.
- Washing machine. Look on the wall behind the washer for hot and cold valves.
- Ice maker. The valve is under the sink or behind the fridge.
- Water heater. The valve is on the cold line at the top of the tank.
A failed supply line is a common cause of sudden flooding. That is the short flexible hose from the valve to the toilet, faucet or washer. Look at yours for bulges, rust or frayed spots. Swap out any that look worn, and replace washer hoses every few years.
Fixture valves wear out too. Many older ones take several turns to close and get crusted with scale. Turn each one off and on once a year. If one won't close all the way, or it drips at the handle, have it replaced.
Burst Pipe, Slab Leak or Water Heater? How to Tell
Not all water on the floor comes from a burst pipe. The source changes what you shut off and what kind of repair you need. Here is a rough guide.
| What you see | Likely cause and first step |
|---|---|
| Water spraying from a wall, ceiling or cabinet | Burst pipe or failed hose. Shut off the main or the fixture valve. |
| Water pooling around the water heater | Tank or fitting leak. Turn off the heater and close its cold valve. |
| A warm floor and the sound of running water | Possible slab leak. Shut off the main and call a plumber. |
| Water seeping up through flooring or grout | Possible slab leak. Shut off the main and call a plumber. |
| Water only when a sink, tub or toilet drains | Drain leak, not a water pipe. Stop using that fixture. |
| A wet ceiling under a bathroom | Water line, drain or shower pan leak. Shut off water to that room. |
One simple test helps. Shut off the main and wait for the lines to drain. If the water stops, it was a pipe under pressure. If water shows up only when someone runs a drain, it is a drain leak. A leaking tank keeps dripping until it is empty.
A slab leak rarely looks like a burst pipe. It shows up slowly, as damp flooring or a warm spot on tile. If that sounds like your home, read about slab leak repair. If the heater is the source, see our water heater service.
Why Pipes Burst in Our Two Regions
Freezing is not the main cause here. In colder states, frozen pipes cause many bursts. In Orange County and the Central Valley, bursts usually come from high water pressure, old fittings, worn copper or a failed supply hose. That matters, because it means the next one can often be prevented.
Each region has its own weak spots:
- Orange County tracts. Many 1960s and 70s homes have aging copper and hard water.
- Older valley neighborhoods. Fresno's Tower District, downtown Bakersfield and parts of Visalia still have galvanized pipe.
- Valley groundwater. Hard water leaves scale that wears valves and fittings.
- Valley freeze nights. A few winter nights drop below freezing on the valley floor.
On a freeze night, pipes in an unheated garage, an attic or an outdoor run can split. Often the leak only shows when the pipe thaws the next morning.
When to Call a Professional
Call once the water is off and everyone is safe. Our office hours are Monday to Friday, 8am to 5pm. Emergency calls are taken by phone. Tell us what happened, and we'll talk through what to do next.
Have This Ready When You Call
- Location. Is the leak in a wall, ceiling, cabinet, floor or yard?
- Pipe type. Can you see copper, plastic or steel?
- Main valve. Is it off, and did it stop the water?
- Home age. About when was the house built?
- Other systems. Is the water heater or any wiring involved?
A clear picture helps us give you a free phone quote and plan the right repair. Orange Independent Plumbing Services is family-owned. You talk to the people who do the work.
What You Can Do Yourself
Shutting off valves, draining lines and drying small spills are safe for most homeowners. So is swapping a split braided hose under a sink, if the valve works. Beyond that, the limits come quickly.
Leave These to a Licensed Plumber
- Hidden pipe. Anything inside a wall, ceiling or under the floor.
- Main line work. Cutting into the main or soldering copper.
- Heater hookups. Gas or electric connections on a water heater.
- A bad main valve. It won't shut off or it leaks at the stem.
- Water near wiring. Any leak near your electrical panel.
- Tape patches. Never turn the water back on to test one.
What the Repair Visit Looks Like
Every repair starts with the cause. Sometimes a burst is just one old fitting. Other times it points to high pressure, worn copper or a bigger problem in the system. Here is how a typical visit goes.
- Find the break. We look at the damage and trace the water to its source.
- Open access. If the pipe is in a wall or ceiling, a section of drywall comes out.
- Cut out the bad section. The damaged pipe is removed back to solid pipe.
- Put in new pipe. We match the copper, or use PEX (flexible plastic water pipe) where it fits.
- Test the repair. Water goes back on slowly while we check every joint.
- Look for the cause. We check water pressure and the condition of nearby pipe.
- Explain the options. You hear what we found and what, if anything, should come next.
Drywall patching, paint and new flooring are often handled by a separate contractor or a cleanup company. Ask about this when you call, so you know who handles what.
A break on your water service line is a different job. That is the pipe from the meter to your house, and it is usually buried in the yard. Read about water line repair and replacement.
What Drives the Cost of a Burst Pipe Repair
We don't list prices. Two burst pipes can be very different jobs. A split supply hose under a sink is a small repair. A broken copper line in a second-floor ceiling is a much bigger one. Here is what changes the price.
- Where the pipe is. Pipes in walls, ceilings or under slabs take longer to reach.
- Pipe material. Old galvanized steel may need more pipe replaced than copper or PEX.
- Size of the break. A pinhole needs a short repair. A long split needs more pipe.
- Nearby pipe. Worn pipe next to the break may need replacing too.
- Number of leaks. More than one failure means more work.
- Yard digging. A buried water service line adds labor.
- Related fixes. A failed pressure regulator or valve adds parts.
Call us and describe what you see, and we'll give you a free quote over the phone. Military and law enforcement households get 10% off.
Is this your second or third leak in a short time? Ask about the bigger picture. Book general plumbing repair and talk it through.
Insurance and Water Damage Cleanup Basics
Every policy is different. Read yours or call your agent. In general, many homeowner policies cover sudden water damage, like a burst pipe. Many do not cover damage from a slow leak that went on for months. The pipe repair itself may or may not be covered, so ask.
Steps That Help Your Claim
- Stop the water first. Most policies expect you to limit the damage.
- Take photos and video before cleanup starts.
- Keep the broken pipe and your plumber's invoice.
- Write down when you found the leak and what you did.
- Save receipts for fans, towels, hotel stays and meals.
- Call your insurer early, before big cleanup work begins.
Drying Out
Mold can start in a day or two. Wet drywall, carpet pad and wood are where it grows. That is why drying matters as much as the pipe repair. Small spills can be dried with fans and open windows. Larger floods usually need a water damage cleanup company with big air movers and moisture meters.
Ask the cleanup crew to check for moisture inside walls and under flooring. Wet insulation and baseboards can look dry while staying damp inside.
Preventing the Next Burst Pipe
Most bursts here come from pressure, age and wear. The good news is that you can check for most of those before something breaks.
- Test your water pressure. Most homes should sit around 40 to 80 psi.
- Replace a worn pressure regulator if your gauge reads high.
- Replace old supply hoses on toilets, sinks and washers.
- Turn every shutoff valve off and on once a year.
- Flush your water heater to control hard water sediment.
- Check the water meter with everything turned off.
- Think about a repipe if you keep patching leaks.
Our slab leak prevention guide covers each step.
Heat and Cold in the Central Valley
Valley summers add one more item. Garage and attic water heaters bake in the heat for months. Check the tank, its fittings and the relief valve line each spring.
Hard freezes are rare in both regions, but they do happen. The valley floor gets a few cold winter nights, and foothill homes like those near Springville see more. If a freeze is forecast, cover outdoor pipes and hose bibs.
If You Smell Gas, That Is a Different Emergency
A water leak is a mess. A gas leak is a danger. If you smell rotten eggs or hear hissing near a gas line or water heater, don't look for the leak.
- Get everyone out of the home right away.
- Don't flip light switches or start a car in the garage.
- Don't light a match or use anything with a flame.
- Once you are outside and away from the home, call your gas company or 911.
- Don't go back inside until the gas company says it is safe.
After the gas company makes the home safe, a licensed plumber can repair the gas line. Gas line repairs need a pressure test, and most cities require a permit.
Need a Plumber in the Central Valley or Orange County? Orange Independent Plumbing Is Ready to Help
A burst pipe is stressful, but the right first steps keep the damage down. Orange Independent Plumbing is family-owned, licensed and bonded, and has served homeowners since 2015. Our California license is C-36 #1005919. Tell us what happened for a free phone quote.
We serve the Central Valley, from Bakersfield to Fresno, including Fresno, Bakersfield and Visalia. In Orange County, we serve Orange, Irvine, Tustin and Yorba Linda, plus Corona.
- Central Valley. Call (559) 706-2285.
- Orange County. Call (714) 904-6988.
Or contact us today to schedule service.